CAT D8T
Cena brez DDV
24
Priljubljena
Delež
Shrani iskanjeNatisni
INFORMACIJE
Kategorija stroja / vozila
Buldožerji goseničarji
Znamka /model
CAT D8T
Leto izdelave
2012
Delovne ure
6,615 h
Kraj stroja
London, Ontario
Država
Kanada
Mascus ID
36BD56A8
CENA
Izberite valuto
PODROBNOSTI
Drugi podatki
CAT D8T
CAT C15 ACERT Engine
Engine Block Heater
Powershift Transmission
Cab (ROPS) w/ A/C
Differential Steer
Fuel Tank Guards
24" Extreme Service Track Shoes
CAT Angle Blade w/ Twin Tilt - 180" Wide
CAT SU Blade is Available
Carco H140 Winch & Fairleads
Rear Screen
CAT SS or MS Ripper is Available
High Speed Oil Change
Accugrade Ready
Flood Light Arrangement
Rear View Camera
Oil Samples Available
Rated at 364 HP
Weight 82,000 LBS.
Fully Maintained By CAT Dealer, Equipped with Choice of Semi U Blade or Angle Blade, 24" Extreme Service Track Shoes & Drawbar. Optional Winch & Rippers are Available. On Arrival to our Yard, Toromont CAT Completed a TA1 Inspection Including Pressure Checks, Performance Checks & Cutting Apart All Oil Filters for Inspection. All Needed Repairs & Servicing as a Result of this Inspection will be Completed. WARRANTY INCLUDED.
The following are repairs completed by the CAT Dealer prior to Marcel Equipment owning the machine;
At 1,925 hours, installed NEW DPF filter
At 2,228 hours, installed NEW a/c evaporator
At 3,029 hours, installed NEW ARD head
At 3,214 hours, resealed transmission pump & installed NEW u-joints
At 3,214 hours, resealed implement pump
At 3,908 hours, installed NEW segments, idlers, rollers & track chains
At 6,601 hours, installed NEW a/c condenser, dryer & accumulator
At 6,685 hours, performed 1,000 hour service
When unit arrived in yard, MEL had local CAT dealer complete the following:
Strip machine for power washing
CAT TA inspection
Update ECM flash files
Cut open all filters & inspect for contaminates - all clean
Service emissions system if needed (filters, dpf, spark plug, injector, etc)
Service engine
Inspect magnetic plugs/screens & suction screens - all clean
Check oil levels
Inspect oils for discolouration
Check for logged & active codes & repair
Check for applicable service letters
Completed the following pressure checks to ensure within OEM spec:
Engine rpm high & low idle
Engine oil high & low idle pressures
Fuel pressure
Full stall boost
Full stall speed
Transmission pump pressure
Transmission lube pressure - low/high
Transmission clutch pressures
Torque inlet pressure
Torque outlet pressure
Torque convertor stall speed
Torque convertor lock-up clutch
Flywheel low pressure - low/high
Implement stand-by pressure
Margin pressure
High pressure cut-off
Pilot pressure
Accumulator pressures
Steering charge pressure
Brake pressure
Steering high pressure cut off
Hoist relief pressure
Brake cut-in/cut-out pressure
Fan pressures, speeds & calibration
Based on inspection, Caterpillar mechanic completed the following repairs;
Installed NEW ARD head spark plug
Completed 5,000 hour emission service
Field cleaned DPF filter
Completed engine valve set & injector set
Resealed valve cover
Resealed exhaust manifold & installed NEW studs
Resealed engine oil pan
Installed NEW track cannon seal on left side
Replaced all required hoses/lines
Tested & serviced batteries & connections
Completed required cab repairs
Completed misc repairs on machine
Greased machine
Machine is now ready to go to work!
Naprej
Marcel Equipment Limited
1000 Progress Drive N6N 1B8 London Ontario Kanada
11
Leta na MascusuSledite temu trgovcu
Prijavi sumljiv oglas